Here’s the normal sequence for creating plots and capturing data using Plot and Veusz:. Good luck and happy plotting! Message 10 of The problem is I have to write down each and every reading. It is an autobalancing bridge, which provides remarkable wide range and accuracy, from Hz to MHz.
|Date Added:||15 February 2018|
|File Size:||32.82 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Agilent 4194 Analyzer
They are the same that are available over comms, but hp4149a are worded a little differently. Most things are documented in the manual.
With this one, you can get specific readings, or the whole sweep.
You can immediately see marker values, and get a quick sense of the range and scale of both the plots and the frequency range. I have written many programs for this, but I didn’t use the drivers.
Min, max, center, and span are not very helpful. Message 3 of Most Active Hardware Boards: Only the log grid lines for magnitude are shown; the phase trace has no horizontal grid lines at all.
HP a Analyzer LabView Libraries?
I suggest that you become familiar with the parameters that lbview available to use. It is an autobalancing bridge, which provides remarkable wide range and accuracy, from Hz to MHz. A driver would have all of the instruments commands necessary to communicate with it. Pretty ugly, isn’t it? Here is an example. Message 6 of Click the “add file” button labvoew to the Data File box and specify where you want the. When you click on an object it is highlighted in the plot display, so you can see what it is you’re modifying.
Agilent Analyzer – IEEE (GPIB) Driver for LabVIEW – National Instruments
I can do all the calibration and settings from the front panel. Here’s the normal sequence for creating plots and capturing data using Plot and Veusz:. All you need to do is click Capture. When you double-click on Plot. All I need is, once I am done with the frequency sweep fro my experiment, I want the program to grab the data from the LCD screen and put it into a excel sheet or a txt file. My program does a cap sweep.
Unzip the file and run setup. I was wondering if anyone already has a program written for extracting the data and storing in a excel or a txt file.
Here are a few more examples click to see full resolution: Please let me know. Click the “add file” button next to the Plot File box and point to the VeuszInput.
The program I supplied gets cap and dis data from to Hz over 10 points. Then, when you request array A data, it will be the raw measurements for your sweep set up. You will also need to not assign variables to the array A locations. Create a folder for your plot processing and put these files in it.
Instrument Control (GPIB, Serial, VISA, IVI)
Check my blog for a link to Zfita better alternative to this. Thanks Dennis, I downloaded the drivers. The problem is I have to write down each labviee every reading. It is only 10 points though. Message 5 of